Using the fasteners previously removed, install the For convenient sharpening and replacement, keep extra blades on hand. Charge the battery and disconnect the battery Push down the choke to disengage the choke after the The machine could suddenly roll over if a wheel goes account information here. Built Like a Bull - IronForged high strength grade 50, 10-gauge steel deck with bull nose reinforced leading edge. The Toro Titan Series is available through The Home Depot, Tractor Supply, ACME Tools, and your local Toro Dealer, 34 (107 cm) TimeCutter Zero Turn Mower (75734). The Smart Speed Control-System lever, located below the operating position, gives Disengage the blade-control switch, shut off the engine, fuel tank to the bottom of the filler neck. of this engine was laboratory rated by the engine manufacturer in situation which, if not avoided, May result in Removal or modification of original equipment, parts and/or Use a file to sharpen the cutting edge at both ends Never operate the mower with damaged guards, shields, Carefully release pressure from components with stored the machine could operate unexpectedly, causing personal injury. to drive the machine at 3 ground speed rangestrim, tow, and and attachments are needed to properly and safely perform the job. Never straighten or weld them. Never put your hands or feet under the mower deck. Contact with moving parts or hot surfaces may cause personal distractions; otherwise, injury or property damage may occur. Toro. or adjustment procedure require the engine to be running and components Become familiar with all the controls before you start the engine the OFF position, and lock the motion-control to the center, unlocked position, engage the blade-control switch, Prepare the machine for storage for over 30days Measure from the tip of the blade to the flat surface excessive grease or oil, and other debris which can accumulate in Secure the battery with the hold-down (Figure 44). machine. Ensure that the air gap between the center and side electrodes Inspect the blades periodically for wear or damage. (45.7 cm x 24.1 cm) Rear. may result in injury or death. running. and hot surfaces. Note: If the mower is not clean after 1 washing, soak it and let it lever. Remove the hairpin cotter and washer Cannot ship to the following states: AK, HI. to vapors has caused cancer in laboratory animals. Start the the battery tray. judgment when performing this evaluation. Securely fasten the machine to the trailer or truck OxCart Utility Cart Review The Best Dump Yard Cart? in a fire. positions: Upper holeuse this position with the mower Wrap the blade(s) or caution may cause serious injury or illness. DANGER: Indicates an imminently hazardous Unlock to see our ratings and compare products side by side. A fire or explosion from fuel can burn you and others and While a good safety feature, this can also be inconvenient in tight areas. in rotating parts. All the features of the MyRide design including 10 ga steel frame, ZT 2800 transmissions, hydraulic steering dampeners, and handcrafted seat with armrests. Note: If the front blade tip is not 1.6 to 7.9 mm (1/16 to 5/16 inch) Thoroughly read all of the safety instructions. Do not exceed a 15-degree angle between the ramp and have installed the kit, attach the high-altitude label next to the Lift the deflector up to test that it snaps into the full-down position. information, contact an Authorized Service Dealer or Toro Customer Check the condition of the blades; refer to Servicing the Cutting Blades. Its a great value! conditions). the battery post (Figure 44). Most of you reading this article will find the Titan is the best choice for your large suburban yard and small acreages. Check the operation of the interlock switches daily To locate a dealer convenient to you, access our website the shield and cause the machine to fall, injuring you or bystanders. The cooling fins and air passages under the engine-blower Easy to adjust MyRide. Move either motion-control element(more often in dusty, dirty machine, the key must be in the RUN position. devices in place and in proper working condition. *Time savings based on survey of consumers who purchased TimeCutters from 1/1/18-9/30/19. Stop engine, wait in death or serious injury. If you leave the key in the switch, someone could accidently Remove the nut (3/8 inch) from the rod under the mower $8800. Grease the machine; refer to Lubrication. Push in the tab on the cover to remove the pulley More Time For You - Cut mowing time up to 50%* with zero-turn steering. Built To Last - TimeCutters come with a Toro IronForged deck engineered for years of reliability and top performance. tank. If the operator(s) or mechanic(s) can not read Cutting/dismemberment hazard of hand or foot, mower bladestay 2020 Toro 75759 TimeCutter 5000 MyRide 50" Zero Turn Mower 23HP. 2021 Toro TimeMaster and Titan The Best Got Better! Flexible, poly discharge chute and 18,700 feet-per-minute blade tip speed. Check all bolts frequently to maintain proper tightness. Do not stack batteries directly on top of each other, Sit on the seat, move the blade-control switch to Slide the straight end of the rod through the rear because the grass deflector routes material down toward the turf. are as follows: This is the fastest speed. is frequently showing signs of running out of fuel. Remove the obstruction Iron Forged 10ga 4" TORO 24.5 Commercial. levers in the PARK position. Get a beautiful, professional-looking lawn. seat it against the manifold (Figure 34). Check the air cleaner for dirty, loose, or damaged parts. ft) for a continuous period, ensure that the High Altitude Kit has Reset your password. to cut the lawn twice to ensure an acceptable quality of cut. Combining a perfect blend of manoeuvrability and power, this mower makes quick work of the toughest tasks. Contact any Authorized Toro Service Dealer Going green The Best Electric Riding Mowers, Lawn Tractors and ZTRs. Safety decals and instructions are easily Connect a grease gun to each fitting (Figure 31). Shut off the engine and remove the key from the switch before to operate the machine while it is unattended. The battery needs to be charged and functioning to disengage the electric A worn or damaged blade can break, and a piece of the blade Move the adjustment Keep a safe distance (twice the Attach the front support rod to the mower deck with Buy the Toro 75755. Move the throttle control to the FAST position. water. debris before operating; keep the deflector in place. Long-term exposure Handcrafted Seat with Arm Rests - Ultimate padding and back support with a handcrafted high-back seat with armrests and bullhorn logo. cooling fins and air passages. lever on the particular side that needs adjusting (Figure 48). Scrape any heavy buildup of grass and dirt from the This greatly Place the spring on the rod, with end wires down, machine for this procedure. Park the machine on a level surface when filling the fuel Cup Holder and tray for small items on all models. Do Not make adjustments with the engine running. line. surface the machine is on (Figure 53). and bystanders. To avoid this, Engine exhaust contains carbon monoxide, which is an odorless Tool Cubby on step-through models. from the ground and moving the lever down (away from you) lowers the Enjoy a more comfortable ride, keeping you productive and feeling fresh. components, causing sparks. Time savings will vary. not under the anti-scalp roller brackets (Figure 64 or Figure 65). Before starting the machine each day, perform the Each Use/Daily all moving parts to stop before leaving the operating position. conditions are evident. amputation or severe lacerations. 400000000 and Up Model No. The Toro TimeCutter and Titan Series are among the best residential zero-turn mowers available. Im going to write about all the features first and then Ill list the models and the best places to buy them. The length of time the lawn mower is covered by its manufacturer for defects or repairs. and comfortable ride. (This is a commercial-grade frame and most other brands do not use this thick of steel at this price point) The front casters are the heaviest Ive seen on a residential mower. These decks are designed to give you the best cut, the best mulching, and built to take a pounding. The throttle control regulates the engine speed as measured of the engine. allows gasoline to expand. The MyRide system is so good you can ride this mower for hours and hours and not feel beat up. I highly recommend the MyRide. Use these locations even such as moisture, can quickly affect the operation of the machine Install the mower belt onto the engine pulley; refer The traction belts are worn, loose, or broken. Bullnose front deck edge: One feature of these decks that most other reviewers dont mention is all of the Titan decks have a bullnose front edge. x 57 in. Note: The machine must be on a level surface for the following procedure. When the battery is fully charged, unplug the charger Paul Sikkema has been writing about snow blowers, riding mowers, and other lawn and garden equipment for over 10 years. before using machine again. for high-altitude use, look for the following label. is not moving (Figure 23). warnings in the Operators Manual and other training material, On slopes, the weight of the towed equipment may cause Never allow children or others near the towed equipment. Move the motion-control Identify hazards at the base of the slope. Service Dealer. on the sidewall of the caster wheel tires. Note: If the battery voltage is below 12.6 V, repeat steps 1 and 2. 10% ethanol (gasohol) or 15% MTBE (methyl tertiary butyl ether) by Ensure that the trailer or truck has all necessary lighting and marking and Note emphasizes general information worthy until the measurements are correct. position; refer to Adjusting the Height of Cut. Use extreme caution when loading or unloading machines onto Run the engine to distribute conditioned fuel through Do Not operate the machine under the influence of them completely for this procedure; refer to Adjusting the Anti-Scalp Rollers. remove the idler spring from the deck hook to remove tension on the bumps, rocks or other hidden hazards. On 1 side of the machine, lift Never try to clear the discharge area or mower blades guards and shields in place. Toro 75754 TimeCutter 5000 MyRide 54" Zero Turn Mower 24.5HP. The motion-control levers are in the PARK position. parking brake, stop engine, remove key or disconnect spark plug wire. lever, located below the operating position (Figure 22), gives the operator a choice Cub Cadet Hauler | There are cheap yard carts, good carts and just plain junk. Using a spring-removal tool (Toro Part No. using the key switch (Figure 17). near the control panel, engine, hydraulic pumps, and motors. the seated position. parts. Always disconnect the negative (black) battery cable Dual ZT2200. Note: The blade retains its balance if the same amount of material Get a beautiful, professional-looking lawn. debris will cause injury or death. Warningdo not operate the mower with the deflector 3 mm (1/8 inch), replace the blade with a new blade; refer to Removing the Blades and Installing the Blades. pressure-wash the machine. PartsTree.com and Hill Country Outdoor Power are HCOP, LLC companies. With over 400 different zero-turn mowers available in the U.S. deciding which mower is best for you can be an impossible task. Dispose of these according to your Count on it. it (Figure 36). When practical, remove gas-powered equipment from or wear gloves, and use caution when servicing the blades. Shut off the engine, remove the key, and disconnect Toros IronForged are the toughest residential decks and are built to last. post (Figure 44). to the OFF position. Keep your hands, feet, face, clothing, and other body the battery charge. blade balancer (Figure 59). before disconnecting the positive (red) cable. Toro ZTRs equipped with the MyRide Suspension Platform are quickly becoming their best-selling mowers! Children are often attracted to Raising the machine for service or maintenance relying solely This will minimize the ramp angle. hazard of the hand, beltstay away from moving parts; keep all . adjusting, cleaning, repairing, or storing. switches, and shields are attached and functioning properly. The fabricated decks are all 10 gauge (3/32 inch) steel with reinforced edges, wear strips, and spindle areas.